AT THE HEART OF THE ROAD TRANSPORT INDUSTRY.

Call our Sales Team on 0208 912 2120

DAF

8th June 1989, Page 110
8th June 1989
Page 110
Page 111
Page 112
Page 110, 8th June 1989 — DAF
Close
Noticed an error?
If you've noticed an error in this article please click here to report it so we can fix it.

Which of the following most accurately describes the problem?

FLYING DUTCHMAN

In spite of its small home-grown engine, Daf s four-axle tipper is no sluggard. Neither does the 30 tonner's fuel consumption suffer unduly. The 14-year-old cab, though, is showing its age

IF THERE is any truth in the saying "When the going gets tough the tough get going" then the Daf FAD2500 DHS is rugged indeed. Over CM's on/otT road tipper route it averaged 42.3km/(26.31.mph), making it the quickest eight-wheeler tested so far.

This is all the more remarkable when one considers the size and output of the OHS engine — just 8.25 litres producing 182kW (244hp) at 2,4011rpm with a maximum torque output of 906Nm (668 lbft) at I ,(10Orpm.

For ever-better payloads and performance vehicle manufacturers strive to pare a few kilogrammes here and there, but there is little doubt that the lighter a component the shorter its life will be.

Construction is one business, for instance, where payload capacity comes second to durability. And while fuel costs remain most operators' largest expense, making good fuel consumption a high priority, speed can be a decisive factor for many eight-wheel tipper operators. A large majority of them operate within 50 miles of their home base, so the number of loads a vehicle cm deliver each day is important.

Dal introduced the FAD2500 OHS in 1982. Despite its relatively small capacity turbocharged and charge cooled engine it is no lightweight. indeed, it offers a fairly average body payload of 21.96 tonnes.

Oafs 2.255T twin-spring bogie is a weight saving feature, hut more importantly, it is located through the centre of the chassis giving a high-roll centre and helping roll stability. 'rhe eight-rod configuration with sealed-forlife hearing determines the wheel alignment.

The double-drive bogie, incorporating an inter-axle dill lock and twin limited slip differential within singlg reduction axles, is recommended for all but the worst off-road conditions. The optional 2699T hub-reduction axle provides inter-axle and cross-axle cliff locks and gives a slightly slower gearing ratio.

Both front axles have a.design capacity of over seven tonnes and, linked with a compensatory leaf-spring suspension, provide a welcome degree of latitude in load distribution.

Speed rarely equates well with good fuel consumption. True to form, this Daf 2500 set no economy records, but its average fuel consumption of 50.8 lit./100km (5.56mpg) falls well within a hand established by other vehicles tested over the same course in recent limes.

Our test vehicle, equipped with a 15.3cum (20cuyd) aluminium body and Crown single-rani tipping gear, weighed in at just under the 30-ton legal maximum weight.

An extremely wet test track at the Motor Research Association made the results of any brake test meaningless. Instead, we relied on the results obtained from a rolling brake tester. These show an even distribution As well as a high overall performaiice.

On the road the rear near-side brakes squealed under light Pedal loads, but continued to give a good response. Tipper operation is probably the hardest of any on brake linings so Dal-fits an exhaust brake as standard. Used with the appropriate gear ratio, the frequency

of light service brake applications can be reduced.

Steering is not heavy but, with 5.25 turns of the wheel lock to lock, it has to be worked at.

CV COMFORT

Dafuses the same basic cab shell today as it first sold on the British market back in 1971. Although there have been several improvements over the years it is beginning to show its age. It is unsprung and mounted high on the chassis so that two steps are needed to gain entry. They are wide and placed forward of the front steered axle, which helps them to stay reasonably clean, even in a muddy environment.

Interior trim is practical. The thick rubber mats are easy to clean and dampen engine, transmission and road noise.

Windows on all four sides provide good visibility. The glazed rear panels arc particularly useful when approaching acute angled road jmietions, and with the mirror fixed above the near-side

door window the only blind spot, Jose to the front wheels, is also covered.

The standard Bostrorn suspension scat is a most necessary piece of equipment if driver back ailments are to be avoided. Set to match driver's weight it will smooth out the ride over bumps and potholes of the roughest roads.

The instrumentation and facia layout need redesigning. The heating and ventilation system is basic but sound, though I found that either the roof hatch, quarter light or side window needed to be open for sufficient fresh air.

The larger section of Daf's front screen (made in three parts) is almost flat. While the wipers leave an unswept area at the near-side extremity, they clear close to the top of the screen. Arm mounted jets place the screen wash directly where it does most good.

The cab tilts hydraulically to give clear access to the engine, but for daily fluid level checks the designers have been less accommodating. The oil dip stick pops through the chassis and is tucked away behind the front wheel just the job first thing in the morning on a muddy site!

The full power range of the Dal engine up to 2,400rpm produced a lively acceleration performance, but some of the credit must go to the extremely slick gear movement of the ZF synchromesh double H gate nine-speed range-change gear box.

All old habits of double declutching were quickly oitercome. As I came to accept that only a single clutch movement was needed while pressure was held against the synchros until the gear dro"pped in smoothly at its own pace, the vehicle lost little momentum.

But, the closeness of the four lower ratios caught me out on a short steep off-road ,S ection. This was the one time when the vehicle might have been easier to drive if it had been fitted with the slightly lower geared hub-reduction axle. Daf says, however. that the single

reduction axles are the most popular.

I found no situation that the vehicle could not pull out of. The articulation afforded by the eight torque rod bogies kept the drive wheels firmly in contact with the ground.

HANDLING

for the worst off-road sites drivers often prefer the stability and traction control afforded by a steel suspension. Certainly it offers better cross axle articulation than rubber, although it may not match it on maintenance and durability. As yet Dal does not offer an option.

Daf's 2500 has been available for more than two years. Its 8.25-litre engine and rear suspension are designed to save weight yet the vehicle falls well short of being classed as a light eight-wheeler.

SUMMARY

Through engine turbocharging and charge cooling Dal has achieved a high power-to-capacity ratio and a power-toweight ratio of 5.97kW/tonne (8.I3hp/ton) for the vehicle as a whole. This, together with j well matched drive line, was sufficient fcir it to return the highest average speed of any eightwheeler tested over this route.

Fuel consumption was less spectacular, but the results till within performance range obtained from a number of competitive vehicles.

The old cab shell design is no worse for, being 14 years old and provides a reasonably quiet, comfortable and light environment. While the overall design incorporates some weight-saving features the vehicle is built to take an average payload and not break under die weight.