Ashseries Maxi van
2nd August 1974, Page 24
2nd August 1974
Page 24
Page 24, 2nd August 1974
— Ashseries Maxi van
Close
Noticed an error?
If you've noticed an error in this article please click here to report it so we can fix it.
If you've noticed an error in this article please click here to report it so we can fix it.
THE integral Maxi Van bodywork produced by Coachwork Conversions of Colne, Lancashire, is now available for Ford's A-series chassis cowl units.
The body comes in two capacities of 12.2 cum .(435 cu ft) and 15.9 cu m (565 cu ft) and these will suit wITeelbase options of all the models in the A-series range.
The bodywork is framed in extruded aluminium alloy sections and panelled in 19 gauge half-hard aluminium sheet. The body sides are further braced internally by horizontal top-hat section alumium alloy extrusions which act as tie rails.
Full-depth rear doubledoors are fitted which hinge through 270 degrees and latch flush against the body sides. Sliding doors for driver and passenger are provided.