Hydraulic help for pallet loading
22nd September 1978, Page 24
22nd September 1978
Page 24
Page 24, 22nd September 1978
— Hydraulic help for pallet loading
Close
Noticed an error?
If you've noticed an error in this article please click here to report it so we can fix it.
If you've noticed an error in this article please click here to report it so we can fix it.
ANTHONY Carrimore is to manufacture a new electrohydraulic tailboard loader designed specially to cater for wheeled palletized loads, Both 12and 24-volt power packs are offered with pushbutton controls located inside and outside the body. The hydraulic cylinder is of the displacement type, with the seal operating on a ground hard chrome piston rod, con nected to cables which run over large diameter pulleys through heavy-duty runners down to the timber or steel folding tread plate.
Two models of 1,000kg (20cwt) or 1,5004 (30cwt) to suit either truck or van can be supplied direct to the body builder, fitted at the factory at Stanley, Co Durham, or at any of the York Truck Equipment service depots.