1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164 
V. L. CHURCHILL AND CO LTD.
Page 87
Page 88
If you've noticed an error in this article please click here to report it so we can fix it.
London Road, Daventry, Northants.
THERE are four presses offered by this company, three being operated hydraulically and one mechanically.
The mechanical unit has a capacity of 10
tons and uses a screwed ram-spindle which is operated by a ratchet and pawl, each notch on the ratchet moving the ramTio in. The frame used is identical with that of the 10-ton hydraulic machine described below. The model number of this unit is 37F.
Using a ram with a stroke of 6 in. and powered by a single-speed, hand-operated pump, this model has a fabricated frame made up from mildsteel plate allowing work sizes of 31 in. in height and 22 in. in width to be accommodated. It carries the model number 37H.
A 20-ton-capacity unit having the model number 37XC-1 employs a hydraulically powered ram, again by a single-speed, hand-operated pump which has a travel of 5 in. The frame design follows closely that of the 10-ton model, but construction is much more substantial to withstand the higher stresses imposed upon it. This unit gives a maximum work space between the uprights of 22.5 in. and a maximum depth of 33.625 in.
The largest of the models offered is the 50-ton unit bearing the model number 37UC. This machine is equipped with a two-speed pump with capacities of 2 tons and 50 tons respectively on the low and high pressures. A machined work table is supplied on this model and work up to 41.5 in. wide and 39 in. high can be accommodated. The ram, which has a 12 in. stroke, is 5 in. in dia. A number of special attachments are available for use with this machine.