I have been told there is a method of "cutting
24th April 1970, Page 65
24th April 1970
Page 65
Page 65, 24th April 1970
— I have been told there is a method of "cutting
Close
Noticed an error?
If you've noticed an error in this article please click here to report it so we can fix it.
If you've noticed an error in this article please click here to report it so we can fix it.
out" diesel engines when they overheat. Can you supply any helpful information whereby we could fit up our vehicles against overheating?
AWe recently published a piece on this subject (on page 63 of the January 23 issue this year) in the Transport Servicing and Equipment columns. The unit mentioned is made by the Cummins Engine Co, Coombe House, St George's Square, New Malden, Surrey.
In the same section, but in the January 9 issue on page 27, a similar device suitable for all makes of engines was featured. This was called the S and S Enginemaster and marketed by P. and J. Gehler, PO Box 22, 21 Cedar Court, Imperial, Windsor, Berks.